Hans Grohe Raindance Connect Showerpipe 27164001 Uživatelský manuál

Raindance ConnectShowerpipe27164001Installation Instructions / Warranty

10Replacement Parts1 hose 282550002 slider 987140003 riser 967700004 escutcheon 986720005 wall flange 986730006 shower arm 98

11Limited Lifetime Consumer WarrantyThis product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”).

Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004Tel. 770-360-9880 • Fax 770-360-9887www.hansgrohe-usa.comthe product for use pri

2Raindance Connect Showerpipe27164001Suggested installation

3Technical InformationMax. water pressure 147 psiRecommended water pressure 29 - 72 psiTest pressure 232 psiMax. flow rate showerhead 2.5 gpm ha

4InstallationDrill the screw holes with a 6 mm bit.Install the anchors. If both ends of the showerpipe are mounted on tile, install the top and botto

5If the bottom of the showerpipe is mounted on tile, but the top is not, install the top wall flange with the tile matching disk.Push the shower arm a

6Install the showerhead on the shower arm. Use a level to make sure that the shower arm is straight. If it is not, loosen the mounting screws slight

7Tighten the shower arm safety screw with a 2 mm Allen wrench. Place a hose washer in one end of the hose. Connect this end to the water supply (not

8User instructionsWhen the water is turned on, it will come from the handshower.To use the showerhead, push the handshower up into the handshower hold

9Scale removalThe showerhead and the handshower use the Quick Clean™ cleaning system. If scale deposits are noticed in the spray channels, turn the w